Plus Size Leather Skirts

Faux leather is the one fabric where the pleats either hold or collapse, and that comes down to the base cloth rather than the shine. The skirts in this collection sit on a 95% polyurethane, 5% spandex base: the polyurethane gives the surface its soft matte hand and lets the pleats hold a knife edge without being pressed, and the spandex is what stops the fabric cracking along the fold lines after a few wears.

Read the construction before the colour. Two shapes sit in this collection. The pleated skort has high-stretch shorts attached inside, plus side pockets, and that is the one for a night where you will be standing, dancing, or getting in and out of a car. The pleated skirt is unlined and hangs as a single layer, which gives a lighter swing and a sharper silhouette, but it will not cover for you on a windy day. Same fabric, different job.

Sizing is where faux leather differs from everything else in our skirt range. PU has almost no crosswise give. A 5% spandex content helps, but it will not stretch over a hip the way a knit does. So do not size down hoping it will relax, and do not assume the elastic waistband buys you a free size. Measure your widest hip and your natural waist, then take the larger of the two against our chart. Our sizes run S through 5XL depending on the colourway, with most styles starting at XL and running to 5XL. Check the size selector on the specific piece, because the shortest runs are on the limited colours.

Length and rise: these are high-waisted and pull-on, cut to sit at or just below the natural waist so the waistband does not cut across a softer midsection. Mini length lands at upper thigh. The pleats add volume at the hem, which is why the A-line flare reads as skater rather than pencil.

How to wear it: the black pleated skort with a fine knit and ankle boots, brown or green with a tucked shirt for the office, or the whole thing with a band tee for a gig. Care: wipe with a damp cloth, hang to air, and never machine wash or tumble dry, because heat is what makes PU flake. Iron on the reverse only, on the lowest setting, through a cloth.

Sort by
  • Featured
  • Most relevant
  • Best selling
  • Alphabetically, A-Z
  • Alphabetically, Z-A
  • Price, low to high
  • Price, high to low
  • Date, old to new
  • Date, new to old

FAQs

Got a question? We are here to answer